User guide

(118PO) ULTRA FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2012
118
PO
SAVE THESE INSTRUCTIONS
Page 10
English
STORAGE
POOL MAINTENANCE & DRAINAGE
Donotaddchemicalsifthepoolisoccupied.Thiscancauseskinoreyeirritation.
Concentrated chlorine solutions can damage the pool liner. In no event is Intex Recreation
Corp.,IntexDevelopmentCo.Ltd.,theirrelatedcompanies,authorizedagentsandservice
centers, retailers or employees liable to the buyer or any other party for the costs
associated with the loss of pool water, chemicals or water damage. Keep spare filter
cartridgesonhand.Replacecartridgeseverytwoweeks.Werecommendtheuseofa
Krystal Clear™ Intex Filter Pump with all of our above-ground-pools. To purchase an
Intex Filter Pump or other accessories see your local retailer, visit our website or call
the Intex Consumer Services Department listed in the separate “Authorized Service
Centers” sheet and have your Visa or Mastercard ready.
EXCESSIVE RAIN: To avoid damage to the pool and over filling, immediately drain rain water that
causes the water level to be higher than the maximum.
How to Drain Your Pool and Long Term Storage
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Check to make sure that the drain plug inside the pool is plugged in place.
3. Remove the cap from the drain valve on the outside pool wall.
4. Attach the female end of the garden hose to the drain connector (8).
5. Place the other end of the hose in an area where the water can be safely drained away from the
house and other nearby structures.
6. Attach the drain connector to the drain valve. NOTE: The drain connector will push the drain
plug open inside the pool and water will start to drain immediately.
7. Whenthewaterstopsdraining,startliftingthepoolfromthesideoppositethedrain,leadingany
remaining water to the drain and emptying the pool completely.
8. Disconnecthoseandadapterwhenfinished.
9. Re-insert drain plug in drain valve on inside of pool for storage.
10. Replace drain cap on outside of pool.
11. Reverse set up instructions to disassemble the pool, and remove all connecting parts.
12. Be sure that the pool and all parts are completely dry before storage. Air dry the liner in the sun for
an hour before folding (see drawing 5).Sprinklesometalcumpowdertopreventthevinylfrom
sticking together and to absorb any residual moisture.
13. Createasquareshape.Startingatoneside,foldone-sixthoflinerinonitselftwice.Dothesameon
the opposite side (see drawings 6.1 & 6.2).
14. Once you have created two opposing folded sides, simply fold one over the other like closing a book
(see drawings 7.1 & 7.2).
15. Fold the two long ends to the middle (see drawing 8).
16. Fold one over the other like closing a book and finally compact the liner (see drawing 9).
17. Storethelinerandaccessoriesinadry,temperaturecontrolled,between32degreesFahrenheit
 (0degreesCelsius)and104degreesFahrenheit(40degreesCelsius),storagelocation.
18. The original packing can be used for storage.
7.1
5
6.1 6.2
7.2 8 9
CAUTION
ALWAYSFOLLOWTHECHEMICALMANUFACTURER'S
DIRECTIONS,ANDTHEHEALTHANDHAZARDWARNINGS.