Owner's manual

(86PO) EASY SET POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/02/2012
86PO
S AVE THESE INSTRUCTIONS
Page 9
English
SETUP INSTRUCTIONS
POOL SETUP (continued)
1
WATER
LEVEL
Level
2
3
IMPORTANT
Properinationofthetopring.
The ambient temperatures of air and water have an effect on the internal pressure of
the top ring. To maintain a correct internal pressure, it is best to leave some room for
expansion as the sun heats the air inside the ring. During very hot weather, you
must check to see whether it is necessary to release some air. This is to avoid any
possible damage to the ring.
In no event shall Intex, their authorized agents or employees be liable for
damages (such as pin holes) to the inatable top ring caused by negligence,
ordinary wear and tear, abuse and carelessness, or external forces.
YoumayhavepurchasedthispoolwiththeIntexKrystalClear™lterpump.The
pump has its own separate set of installation instructions. First assemble your pool
unitandthensetupthelterpump.
Estimatedassemblytime10~30minutes.(Notetheassemblytimeisonly
approximateandindividualassemblyexperiencemayvary.)
1. Liner preparation
• Findaat,levellocationthatisfreeandclearofstones,branchesorothersharpobjects
that may puncture the pool liner or cause injury.
• Openthecartoncontainingtheliner,etc.,verycarefullyasthiscartoncanbeusedto 
store the pool during the winter months or when not in use.
• Takeoutthegroundcloth(3) and spread it
over the cleared area. Then take out the
liner (1) and spread it out over the ground
cloth, with the drain valve directed towards
the draining area. Place the drain valve away
from the house.
IMPORTANT: Always set up the pool unit
with at least 2 persons. Do not drag the
liner across the ground as this can cause
liner damage and pool leakage (see drawing 2).
• Duringthesetupofthepoolliner,pointthe
hose connections or openings in the
direction of the electrical power source. The
outer edge of the pool should be within
 reachofthepump’selectricalconnection.
• Layoutthepool.Spreadouttheplainblue
 sidesandmakethepooloorassmoothas
possible (see drawing 2).
2. Ring ination
• Flipthetopringoutandcheckthatitisfully
 outsideofthewallliningandfacingup.Inate
the ring with a manual air pump (see
drawing 3).Keepthetopringcenteredinthe
middle of the pool, while doing this.
IMPORTANT: Prevent bursting by not using
a high-pressure pump, such as an air
compressor. Do not over inate. Preferably
use an Intex manual ination hand pump
(not included).
3. Hose connectors
• Thefollowingappliestopoollinerswithhoseconnectors(16"(488cm)&belowpools).
If the pool was purchased withoutalterpump,inserttwoblackplugs (2) into the black
 lterpumpoutlets.Dothisfromtheinsideofthepoolsothatwaterwillnotrunoutwhen
 llingit.
• Ifthepoolwaspurchased withalterpump,readtheKrystalClear™FilterPump 
 Manualrstandthen proceed to next installation step.
FILLLINE