Owner manual

87PO

SAVE THESE INSTRUCTIONS

English

(87PO) ROUND METAL FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 06/13/2013

Page 9

POOL SETUP (continued)

YoumayhavepurchasedthispoolwiththeIntexKrystalClear™filterpump.Thepumphasitsown

separatesetofinstallationinstructions.Firstassembleyourpoolunitandthensetupthefilterpump.

Estimatedassemblytime30-60minutes.(Notetheassemblytimeisonlyapproximateandindividual

assemblyexperiencemayvary.)

1. Liner preparation

• Findaflat,levellocationthatisfreeandclearofstones,branchesorothersharpobjectsthatmay

 puncturethepoollinerorcauseinjury.

• Openthecartoncontainingtheliner,joints,legs,etc.,verycarefullyasthiscartoncanbeusedtostore 

 thepoolduringthewintermonthsorwhennotinuse.

• Takeoutthegroundcloth(10)(optional)andspreaditover

 theclearedarea.Thentakeouttheliner(7)andspreadit

 outoverthegroundcloth,withthedrainvalvedirected 

 towardsthedrainingarea.Placethedrainvalveawayfrom

 thehouse.Allowthesuntowarmupthelinerbefore

 insertingthebeams(6)intothesleeveopenings.

IMPORTANT: Always set up the pool unit with at least 2

persons. Do not drag the liner across the ground as

this can cause liner damage and pool leakage (see

drawing 1).

• Duringthesetupofthispoolliner,pointthehoseconnectionsoropeningsinthedirectionoftheelectric 

 powersource.Theouteredgeofthepoolshouldbewithinreachofthepump’selectricalconnection.

2. Frame assembly

• Theframepool’slegs(8)andbeams(6)fallintotwogroups.Thelargerdiametersarethehorizontal 

 beamsthatareslid(pushed)intothesleeveopeningsatthetopoftheliner.Thesmallerdiametersare 

 theverticallegs.BoththeselegsandbeamsfitintotheT-joints(3).

• Startingatanylocation,butalwaysworkinginthesamedirection,push

 thehorizontalbeamintothesleeve.Oncethebeamiscenteredtake

 oneoftheT-jointsandusingtheconnectionpin(1),attachthejointto

 oneendofthebeambyinsertingthepinthroughtheseal(2) and in the

 pre-drilledholes.Repeatthisprocedureinacircularfashionuntilallthe

 beamsandjointshavebeenconnected(see drawing 2.1).

The last joint connection may be difficult to complete. You can do

it though, if you first simultaneously raisethe last joint and beam

about 2 inches (5 cm). Now insert the beam into the joint while

lowering the pieces into position. The beam will easily slide into

the joint (see drawing 2.2). Ensure that the last joint is fully

connected before proceeding to connecting the legs.

2.1

2.2