Owner manual

87PO
SAVE THESE INSTRUCTIONS
English
(87PO) ROUND METAL FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 06/13/2013
Page 10
POOL SETUP (continued)
• Nextslidetheverticallegsintothebeltlooplocatedinthemiddleof
 thepoolliner.Thebottomofthelegshouldbeinsidethewhite
 restrainingrope(9)(optional)locatedneartheliner’sbottomedge. 
 Exceptionsarethe10’(305cm)and12’(366cm)sizepools.Carefully
 slidethelegintothebeltloopandplacetheleg’sbottominsidethe 
 ropeandtheninsertthetopofthelegintothebottomofthejoint.
 Snapthislegintojoint’sholesbyaligningtheholesandthe
 spring-loadedpin.Attachtheleg’sendcap(5)tothebottomofthe
leg (see drawings 3.1 & 3.2).
• Uponconnectingthelastleg,grabholdoftheframepool’stopbeams
 in2–3locations.Shakethepooltobesurethatallthejoints,legs
 andbeamsfitintoeachother.Ensurethatallpinsareinpositionby
 pushingthemdownwardsthroughtheholes(see drawing 4.1).
• Pullgently,inanoutwarddirection,thebottomofeachleg;making 
 surethelegisinsidetherestrainingrope.Thelegistoendupinan
 uprightverticalposition.
3. Filling of the pool
• Thefollowingappliestopoollinerswithhoseconnectors(16’(488cm)&belowpools).Ifthepoolwas 
 purchasedwithoutafilterpump,inserttwoofthethreeplugs(11)intotheblackfilterpumpoutlets.Do 
 thisfromtheinsideofthepoolsothatwaterwillnotrunoutwhenfillingit.Ifthepoolwaspurchased
withafilterpump,readtheKrystalClear™FilterPumpManualfirstandthenproceedtonextinstallation
 step.
• Beforefillingthepoolwithwater,ensurethatthedrainpluginsidethepoolisclosedandthatthedrain 
 capontheoutsideisscrewedontightly.Fillthepoolwithnomorethan1inch(2.5cm)ofwater.Check 
 toseewhetherthewaterislevel.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting
up the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging
and a potential collapse of the pool. If the pool is not completely level, you must drain the pool,
level the area or move the pool to a different area that is level, and re-fill the pool, following the
above directions.
• Smoothoutthebottomlinerwrinkles(frominsidethepool)bypushingoutwherethepoolfloorandpool
 sidesmeet.Or,(fromoutsidepool)reachunderthesideofthepool,graspthepoolfloorandpullin 
 anoutwarddirection.Ifthegroundclothiscausingthewrinkles,have2peoplepullfromoppositesidesto
 removeallwrinkles.Usetheproperlyassembledpoolladderwhenenteringorexitingthepoolduringthis
 process.
IMPORTANT: For certain pool models with restraining rope at the bottom – Never pull from the
restraining rope to smooth out the floor wrinkles as this may cause pool liner damage or leakage.
• Fillthepoolwithwateruptojustbelowthesleeveline.
(see drawing 4.2).
4. Posting aquatic safety signs
 SelectahighlyvisibleareanearthepooltoposttheDanger
 NoDivingorJumpingsignincludedlaterinthismanual.
4.2
FILLLINE
3.1
8
9
5
3
3.2
4
4.1