Installation Guide

RS70 Providence Rail System Installation Instructions
RS70INST-1 (05/06/2019)
• Intex offers 45 degree and 90 degree directional change brackets
(sold separately). These can be used to change rail direction within the
span, while leaving the connections to the newel(s) flush. Two brackets
are required (one for the top rail, one for the bottom rail). Item #’s RS70-
45BKT and RS70-90BKT.
• Reinforcements and PVC must be cut to the appropriate angle (for
a 90 degree turn, cut to 45 degrees, for a 45 degree turn, cut to 22-1/2
degrees).
• Crush Block(s) must be used at, or near each turn.
In-Line Rail Elevation change, Adjustable, not at a Newel.
• Intex offers an inline elevation change bracket kit (sold separately).
The brackets are adjustable by bending to the required angle, and
will change the rail direction up or down. Two brackets are required
(one for the top rail, one for the bottom rail). Item # RS70-180BKT
• Reinforcements and PVC must be cut to the appropriate angle.
• Crush Block(s) must be used at, or near each turn.