Installation Guide

Page 3 of 3
d. Use the Velcro straps provided to keep the halves properly aligned, and secure with stainless steel finish nails
as with first half. Wipe off any excess adhesive.
3. Trim Installation
a. Once adhesive has set on Post Wrap, install top wrap around upper end of column. Place adhesive in the
folds and on the open miter edges. Use Velcro strap to hold in place and secure with stainless steel finish
nails.
b. Repeat step a with bottom wrap.
c. Position and attach pre-mitered WM164 cap and base trim at the lower edge of the top wrap and at the upper
edge of the bottom wrap, securing with adhesive and stainless steel finish nails.
d. Fill all nail holes with a quality exterior grade vinyl spackle such as White Lightning brand.
Column,
Newel or
Post size
Plain, Raised
or Fluted
Panel Sides
Recessed Panel Sides
Plain, Raised
or Fluted
Panel Sides
Recessed Panel Sides
Builders Series Post
Wrap
6"
4-3/4" 4-3/4" @ top & bottom, 4" at center 4-3/4" 4-3/4" @ top & bottom, 4" at center 5-1/4"
8"
6-3/4" 6-3/4" @ top & bottom, 6" at center 6-3/4" 6-3/4" @ top & bottom, 6" at center 7-1/4"
10"
8-3/4" 8-3/4" @ top & bottom, 8" at center 8-3/4" 8-3/4" @ top & bottom, 8" at center 9-1/4"
12"
10-3/4" 10-3/4" @ top & bottom, 10" at center 10-3/4" 10-3/4" @ top & bottom, 10" at center 11-1/4"
Column Wraps Newel Covers
Column Wraps, Newel Covers & Post Wraps Inside Clearance