User's Manual

(303PO) MODEL SM24101 SWIMMING MACHINE ENGLISH 7.5” X 10.3” PANTONE 295U 02/21/2017
303
PO
SAVE THESE INSTRUCTIONS
English
Page 11
6.3
5
1
• Adjust the nut on the swimming machine
until the support plate is against the pool
wall and the swim-trainer unit is perfectly
horizontal
(see figure 5.5).
C: For In Ground Pools
1. Mounting Bracket Assembly (see
figures 6.1 to 6.3):
• Makesurethetopsurfaceofthepool
edge is stable, flat and level.
• Payattentiontotheelectrical,gasand
water lines when drilling the holes.
• All screws provided must be used.
• Drill two holes on the center of the
short-end side of the pool edge where the
 mountingbracketwillbeinstalled.Insert
the in ground pool screws
(5)
into the
 holes,andmakesurethescrewsare
fully inserted
(see figures 6.1 to 6.2)
.
• Place the in ground pool mounting
 bracket
(1)
over the installed screws
(5)
and tighten the nuts securely
(see figure 6.3)
.
SETUP INSTRUCTIONS (continued)
5.5
Water level
90
Degree
Ajustable nut
for adjusting the
distance
215mm(8.5”)
332mm(13”)
6.1
5
100~250mm(4~10”)
50mm(2”)
Ø10mm(0.4”)
MAX 40mm(1.5”)
6.2
Water level