Operation Manual

36
37
Cleaning the receiver tubes and domes
The receiver tube and the receiver dome should be cleaned regularly. Use a
damp cloth to clean the receiver tube and receiver dome on the outside. Do
not use water when you are cleaning the receiver tubes or the receiver domes.
Please see instruction on page 37 or 39 for how to change the wax guard filter.
Cleaning RIE moulds
1. Separate the mould from the receiver
tube.
2. Clean the RIE mould using a mild soap,
and rinse with lukewarm water.
3. After cleaning, dry RIE moulds thoroughly and remove any residual
water and debris from the tubing utilising an air bulb and wire loop.
Scan a QR code with your
smart phone and watch a
instruction video.
Changing wax guard for NP receiver tube
1. Clean any debris from the old waxguard.
2. Insert the wand into the old waxguard.
3. Twist the wand with the waxguard in a clockwise direction to ensure it is
attached to the wand.
4. Pull the wand and waxguard away from the tube/mould.
5. Insert the old waxguard into the center of the HF3 wheel.
1
2 3 4 5
Scan a QR code with your
smart phone and watch a
instruction video.