USER MANUAL www.interphone.com Export Dept. international.interphone@cellularline.com www.interphone.
1 – Introduction 1.1 Hello! Thank you for choosing our product. InterphoneF5MC is a Bluetooth® helmet headset for wireless entertainment and communication system among multiple bikers. InterphoneF5MC can be installed on most helmets by attachment / detachment quick bracket. The ergonomic shape of the unit is user-friendly also with motorbike gloves. InterphoneF5MC is waterproof tested, up to IP67 protection degree (using the sealant provided). Index: 1.2 Main features 1. Introduction 4 2.
1.3 Box contents 2 – Getting Started B A C 6 2 8 4 D E 1 F 3 7 5 Pic.2 H (1) (2) (3) (4) (5) (6) (7) (8) G J GUIDA RAPIDA IT I K SI CONSIGLIA DI VERIFICARE LA PRESENZA DI AGGIORNAMENTI SOFTWARE SUL SITO WWW.INTERPHONE.COM MFB button UP button DOWN button Volume + button Volume - button Blue led Red/Green/Orange led Connector www.interphone.com Pic.1 2.1 Main Commands (Pic.2) A. Bluetooth® unit B. Microphone for full face helmet C. Microphone for Jet/flip up helmet D. Left speaker E.
If you select a wrong language, follow the steps below: 2.2 Status led (Pic.2) Standby BLUE led (6) flashes every 3 seconds. Intercom active BLUE led (6) is solid . Interphone mobile/GPS connected with 1. Turn off the F5MC. (Press the MFB for 5s, or until the led lights RED). 2. Turn on the F5MC (Press the MFB for 2s). 3. Short press UP button (2). 4. Short press MFB button (1). 5. Short press UP button (2). 6. Press MFB when you hear your language. BLUE led (6) flashes twice every 3 seconds.
3.1 System settings 3 – Settings You can easily customize your F5MC . From Standby mode (Blue led (6) flashing), press UP button (2) and after MFB button (1) to active “SETUP” menu, entering in the main functions Pic.3.
4.1.2 Pairing with an INTERPHONE unit (not MC). 4 – Intercom F5MC allows intercom communication (INTERCOM) between multiple devices in conference mode (people speak at the same time). 4.1 Pairing Before starting the communication between headsets, is necessary to pair together the units. This process has to be done only one time. F5MC will automatically recognize devices previously paired.
Attention: during intercom activation in your F5MC unit, will be prompted the message “intercom connection failed” and after “Intercom active, press center button to disconnect” . This is ok, because only one intercom channel has been activated. 4.3 Intercom communication between three units (from “INTERCOM” menu) To start an intercom communication between your F5MC (unit nr1 Pic. 5) and other two units (units nr2 and 3 Pic. 5) follow these steps: Chapters 4.1.1/4.1.2/4.1.
4.6 Intercom tips Once activated the intercom channel, communication remains active until it is manually stopped by the rider. It is suggested to suspend the intercom conversation, if not necessary, to optimize battery life. During the conference with three/four riders, in order to ensure the best system stability, it is suggested to don’t connect other Bluetooth ® devices (phones, GPS, etc..) to the units. The best behavior of the group conference is guarantee only using Interphone branded intercom units.
5.2 Incoming phone calls 5.4 Phone tips As indicated in chapter 2.6, phone calls have the highest priority and will override each of other F5MC feature. During an incoming phone call these are the possible commands: If two different phones are connected at the same time to a single F5MC unit, the features “Redialling last number” e “Voice dial” can be used only with the FIRST connected phone. The second connected phone can only receive calls, or managed by hand commands directly on the phone.
6 – FM radio F5MC includes an integrated FM RDS radio receiver with memory to store eight radio stations. To start the FM radio listening, with F5MC in Standby mode (led BLUE (6) flashing), push DOWN (3) button for two times and after press the MFB (1) button to activate the “FM RADIO” menu. When the signal strength is not enough weak to activate the re-tune to an alternative frequency, the listening quality could be decreased due to the low quality of signal.
Start/Stop sharing Press UP (2) button until the beep to start/stop the song sharing with Interphone “A” (unit nr.3 chapter 4.3 - Pic.5) Press DOWN (3) button until the beep to start/ stop the song sharing with Interphone “B” (unit nr.2 chapter 4.3 - Pic.5) During the sharing is possible to start an intercom session, as indicated in the following table. On MC unit that is sharing the music Press the MFB (1) button to activate the INTERCOM menu. Press again the MFB (1) button to start an intercom call.
Important information IMPORTANT INFORMATION ON THE PRODUCT BATTERY Do not store the device without charging it. Failure to do so may irreversibly damage the capacity of the battery. Recharge the battery completely every TWO months. IMPORTANT INFORMATION ON PRODUCT WATERPROOFING The external unit (control unit), mated to the connector on the audio kit, is classified IP67 as per the IEC60529 standard, when used with the sealer provided in the package.
