Operation Manual

ENGLISH - 19 ENGLISH - 20
Appendix 1
Menu chart.
INTERCOM
PHONE
MUSIC STREAMING
SET UP
F3MC VOICE MENU DIAGRAM
CALL ID on/o
FULLFACE HELMET/JET HELMET/AUTOMATIC VOLUME CONTROL o
VOICE ANSWER on/o
ERASE PAIRINGS
full/limited VOCAL HELP
ANYCOM SEARCH
INTERCOM DEVICE SEARCH
PAIRING MODE
LANGUAGE SELECTION
press MFB buon to connect the last intercom paired
press to re-dial
press to voice dial
press unl the beep to play/pause
press to select track
press up buon unl the beep to share
press unl you hear the beep
to conrm
use the arrows to scroll through the menu and use the central buon to select
Important informaon
IMPORTANT INFORMATION ON THE PRODUCT BATTERY
Do not store the device without charging it. Failure to do so may irreversibly damage the
capacity of the baery. Recharge the baery completely every TWO months.
IMPORTANT INFORMATION ON PRODUCT WATERPROOFING
The external unit (control unit), mated to the connector on the audio kit, is classied IP67 as
per the IEC60529 standard, when used with the sealer provided in the package. Therefore,
the control unit, when mated to the connector on the audio kit, may be submerged in a
meter of freshwater for a maximum of 30 (thirty) minutes.
Despite this classicaon, the device is not immune to greater stresses, such as prolonged
immersion or high-pressure jets of water.
Using the device in condions of bad weather, at high speeds, may be equivalent to
subjecng it to a high-pressure jet of water.
FOLLOW THESE SUGGESTIONS CAREFULLY TO PREVENT DAMAGE TO THE DEVICE:
Do not immerse the device in freshwater over one metre deep for more than
30 minutes.
Do not store the device when it is wet: dry it with a clean, so cloth. Dry any
water or moisture in the control unit connector and/or the audio kit connector
by applying warm air for at least 10 minutes. This will keep the contacts from
corroding.
Keep the device away from salt water, ionised water, beverages and other
liquids. If the device is exposed to liquids other than freshwater, wash it with
cold, freshwater and dry it carefully with a clean, so cloth.
Keep the device away from high-pressure jets of water.
Be sure to reapply the sealer supplied in the package if the sealer disappears
when the device is used for a prolonged period of me.
Be sure the connector on the audio kit is inserted into the control unit completely.
Otherwise, complete protecon against water and dust is not guaranteed.