Operation Manual

88 User Manual

TECHNICAL SPECIFICATIONS

♦ Power consumption : 12W average; 27W max peak

♦ Power supply : 10 - 35 Volt dc

♦ Interface : NMEA0183

♦ Autopilot Interface : NMEA-0180, NMEA-0180/CDX, NMEA-0183

♦ Display : Color Sunlight Viewable LCD (active area 7")

♦ Display Resolution : 800 x 480 pixels

♦ Cartography : C-MAP BY JEPPESEN C-CARD

♦ Operating temperature range: 0°/+55° C

♦ Memory : Non volatile

♦ Keyboard : Silicon rubber, backlight

♦ Weight : Kg 1,3

FF MODULE 600W-50-200KHZ

TECHNICAL SPECIFICATIONS

♦ Power Output :600W (4800Wpp), 50/200KHz Dual Fre-

quency

♦ Max Depth :213m (700Ft) at 200kHz, 457m(1500Ft)

at 50kHz

♦ Automatic Recognition of the AIRMAR "X-DUCER ID" transducers for best

performance

♦ Advanced Digital Signal Processing

♦ Speed & Temperature Sensor (if available on transducer)

♦ Alarms (shallow water, depth, Fish, temp)

♦ Trip Log, Fish Symbols

♦ STC, Interference Rejection, Automatic noise reduction

♦ A-scope, White Line, Zoom x2/x4

♦ Auto range/gain/frequency/shift/ping rate

When the package containing the chart plotter is first opened, please check it for

the following contents (if any parts are missing contact the dealer the chart plot-

ter was purchased from):

♦ External bracket and I/O cable 1,5 mt/5,9 feet

♦ Chart plotter's protective cover

♦ Fuse 3 Amp. + fuseholder

♦ User Manual

♦ Flush mounting kit

♦ Smart DGPS WAAS Receiver with cable 15 mt/45 feet (CM PRO)

C-CARD INSERTING/REMOVING PROCEDURE

Inserting the C-CARD

Open the door, hold the C-CARD by the long side so that you can see the label and

gently push the C-CARD into the door slot (1). Close the door pushing the C-CARD

in as far as it will go to hold fixed into the chart plotter slot (2). When finished the

door must be right closed (3).