Operation Manual

User Manual

Calibrate Water Temperature : Allows the calibration on the Water Temperature

sensor. Using the readings from a precise temperature measuring device,

insert here a positive/negative offset to display right value on Fish Finder

screens.

Calibrate Aux Temperature : Allows the calibration of the Aux Temperature

sensor. Using the readings from a precise temperature measuring device,

insert here a positive/negative offset to display right value on FF screens.

Restore Defaults : Restores the default values

6.6.12 Alarms Menu

The Alarms menu allows you to define additional sonar alarm settings for Fish

Alarm, Shallow Alarm, Depth Alarm and Temperature Upper/Lower/Rate.

[MENU] + "Alarms" + [ENTER]

Shallow Water : Triggers an alarm when depth becomes shallower than the value set.

Deep Water : Triggers an alarm when depth becomes deeper than the value set.

High Water Temp : Triggers an alarm when the transducer reports a temperature (from TEMP

1 sensor) above the value set.

Low Water Temp: Triggers an alarm when the transducer reports a temperature (from TEMP

1 sensor) below the value set.

Water Temp Rate : Triggers an alarm when the transducer reports a temperature (from TEMP

1 sensor) variation rate above the value set.

Fish Alarm : The options for Fish Alarm set the size of the fishes that, if detected by the unit,

switches an alarm to sound. These options are: Off, Small, Medium, Big and Huge.

The alarm sounds if the set size (or bigger) is detected.

6.6.13 Load Settings from USER C-CARD

Insert the USER C-CARD into the slot, then follow the procedure:

[MENU] + "LOAD SETTINGS FROM USER C-CARD" + [ENTER]

Load the complete settings from the USER C-CARD and changes the active menu

settings.

6.6.14 Save Settings to USER C-CARD

Insert the USER C-CARD into the slot, then follow the procedure:

[MENU] + "SAVE SETTINGS TO USER C-CARD" + [ENTER]

This is useful to avoid the user having to retune up Fish Finder after a Clear RAM

operation or a software update.

6.6.15 Restore Current Preset Defaults

[MENU] + "RESTORE CURRENT PRESET DEFAULTS" + [ENTER]

Restores the default values only for the current presets (see Par. 6.6.1, Preset

Mode) and does not affect the other presets.

6.7 TRANSDUCERS

The transducer is a device that transmits and receives sound waves into the

water. The active component inside the transducer is commonly referred to as an

element but actually is a piezoelectric ceramic material.

Please refer to your dealer and/or installer to choose your transducer. Interphase

suggest

transducers.