Operation Manual

ManualsBrandsInterphase ManualsMarineCHART MASTER iPRO

User Manual

Restart GPS : Restarts all GPS processes. Once executed, the message "Done" is shown.

Diff. Corr. Source : Sets what kind of Differential Correction will be used by the GPS between WAAS

and RTCM (beacon correction).

Navigation Speed :Sets the Navigation Speed among Low Speed, Medium Speed and High Speed.

CM iPRO:

Fish Finder Transmission

The Fish Finder embedded is connected directly to the Port 2. To switch the inter-

nal Fish Finder transmission On/Off follow the procedure:

[MENU] + "SETUP" + [ENTER] + "Input/Output" + [ENTER] + "FISH FINDER

ON/STANDBY" + [ENTER]

Autopilot Connection

Connect the Autopilot to the serial Port 1, 2 or 3.

[MENU] + "SETUP" + [ENTER] + "Input/Output" + [ENTER] + "Port 1/2/3

Output" + [ENTER]

Then choose your preferred setting among the NMEA available settings NMEA

0183 4800-N81-N, NMEA 0180, NMEA 0180/CDX and press [ENTER] to confirm.

External NMEA Connection

Connect the External NMEA to the serial Port 1, 2 or 3.

[MENU] + "SETUP" + [ENTER] + "Input/Output" + [ENTER] + "Port 1/2/3

Input" + [ENTER]

Then choose your preferred setting among the NMEA available settings NMEA

1200-N81-N, NMEA 4800-N81-N, NMEA 4800-N82-N, NMEA 9600-O81-N, NMEA

9600-N81-N and press [ENTER] to confirm.

C-COM GSM PLUS Connection

[MENU] + "SETUP" + [ENTER] + "Input/Output" + [ENTER] + "Port 1 In-

put" + [ENTER] + "C-COM" + [ENTER]

The modem C-COM can be connected also to the Port 2, 3, in this case select the

format on the used port.

NOTE The connection is valid for the C-COM IR and C-COM RS232 too.

Output Sentences

The chart plotter allows customizing the NMEA-0183 sentence transmitted on

each port. Each port can transmit a different set of sentences among: GLL, VTG,

BOD, XTE, BWC, RMA, RMB, RMC, APB, WCV, GGA, HSC, HDG:

[MENU] + "SETUP" + [ENTER] + "Input/Output" + [ENTER] + "Port 1/2/3

Output Sentences" + [ENTER]

NMEA Data Input

Allows the chart plotter to act as a computer terminal and display the incoming

data exactly as it is received:

[MENU] + "SETUP" + [ENTER] + "Input/Output" + [ENTER] + "NMEA Data

Input" + [ENTER]

Cable Wiring page

Shows a window containing the cable wiring related to the quick disconnect bracket:

[MENU] + "SETUP" + [ENTER] + "Input/Output" + [ENTER] + "Cable Wiring"

+ [ENTER]

Send/Receive Routes & Marks

Sets the desired port used for transferring User Points and Routes functions:

[MENU] + "SETUP" + [ENTER] + "Input/Output" + [ENTER] + "Send/Rec

Routes & Marks" + [ENTER] + "Port 1/2/3" + [ENTER]