Operation Manual

User Manual

The list of the dangerous objects found on the charts crossed by the Route is

shown in the Route check report, follow the procedure:

[MENU] + "MENU" + [ENTER] +"ROUTE" + [ENTER] + "ROUTE CHECK

REPORT" + [ENTER] + insert the desired value + [ENTER]

3.3 GOTO FUNCTION

This functions allows you to place the destination point and immediately start

navigating to it.

Goto Cursor

Place the cursor on the desired location + [GOTO] + "CURSOR" + [ENTER]

The destination is placed at the cursor position and you are now navigating to it.

It is a temporary User Point that will be removed when the navigation is stopped.

If the fix is received, the destination is placed on the desired location, otherwise

a warning message is shown. If the destination is already placed, it is possible to

remove the existing destination and place a new one on the cursor position.

Goto Mark on the Chart page

Place the cursor on any existing Mark + [GOTO]

Goto Mark using the User Points List

[GOTO] + "MARK" + [ENTER] + select the desired User Point + [GOTO]

Goto Route using the Select Route menu

[GOTO] + "ROUTE" + [ENTER] + select one of the existing Routes + [ENTER]/

[GOTO]

The destination is placed on the first Waypoint of the selected route and then the

Route Following function is activated.

Stopping Navigation

If the destination has been placed, to remove it:

[GOTO] + [DELETE]

otherwise, to remove the current destination and place a new one at cursor position:

Place the cursor on location to navigate to + [GOTO] + [NEW] + [ENTER]

3.4 USING TRACK

A very useful feature of the chart plotter, is the ability to store and display exactly

where the boat has been. This feature, referred to as Tracking, can provide in-

valuable information about the effect of tide and wind influence on the boat's

progress as well as giving an indication of the helmsman's performance.

When this limit has been reached, the oldest points are deleted and overwritten

by the newest ones.

Setting up a Track Step

Before you use the Track function, it is important to specify the Track step unit: if

you select Distance, the Track point is placed when the distance from its last

stored position is greater than the defined distance; if Time, the Track point is

placed after the defined time.

[MENU] + "MENU" + [ENTER] + "TRACK" + [ENTER] + "STEP UNIT" +

[ENTER] + "DISTANCE"/"TIME" + [ENTER]

You can select the Track step Time [1 sec - 10 min] or distance [0.01 - 10.0] Nm.

Setting a short time/distance interval between Track points is best suited to navi-