User Manual

Units of readout in W/cm² or JW/cm² as shown on display.
Date/Time Stamp
Numerical Values
Graphical Analysis Values (when in Graph mode)
Min reading
Max reading
Average
The ILT770 has the ability to apply meta data to the saved results. See Applying meta data in
section 10 software.
4 GRAPH MODE
The Graph button has four functions (Start Graph, Stop/Review Graph, Data Analysis and
Exit) that cycle forward each time button 4 is pressed. It is not possible to return to a previous
screen.
Before initiating a graph, use button 1 to select the units. You can graph the irradiance in
W/cm2 or you can graph the dose in J/cm2.
GRAPH: Changes the display to graphical mode and start plotting the results and temporarily
storing the readings for final data analysis.
STOP: Stops graphing and holds the display showing the last 60 results.
(NOTE: you cannot return to this screen, to save the results, Press 3, Save)
DATA: Shows the data analysis from when Graph was first pressed, including Min, Max, and
Average. Units will be displayed based on what was selected before starting the graph.
(NOTE: you cannot return to this screen, to save the results, Press 3, Save)
EXIT: Returns the display to numerical / non graphing mode and clears the previous graph
data from the display.
3 & 4 ERASE ALL SAVED DATA
Press and hold both buttons 3 & 4 at the same time to delete all saved readings from the
internal memory of the ILT770.
ILT770 UV METER MANUAL REV A 9/21 Page number 4 of 9