User's Manual

1. Place the prox.pad plus unit in Program mode.

Press:

99 # Master Code * (default is 1234)

A slow blinking yellow LED indicates that the unit

is in Program mode. A steady yellow LED, in

contrast, means that errors were detected during

programming. Error states can be cleared by press-

ing the asterisk * key.

2. To enable this feature, press:

30#1#1#**

The yellow LED continues to blink slowly.

3. To disable this feature, press:

30#1#0#**

The yellow LED continues to blink slowly.

4. Press * to exit Program mode.

4.4.4 Turning Audio

Keypress Feedback

ON/OFF

The A udio Keypress Feedback command enables the

sounder to beep once for each key press. This feature

provides an audio acknowledgment that a particular

key was pressed hard enough for the unit to under-

stand. The factory-shipped default setting is ON, but

it can be toggled ON and O FF as desired using com-

mand 30. NOTE: Acommonreasontoturnthisfeature

OFF is to prevent an unauthorized user from hearing

the audio feedback emitted when an authorized user

enters his/her code.