User's Manual

Sounder After
PIN/Card
1 single beep Valid card access
1longbeep
followed by 1
short beep
User disabled
1longbeep
followed by 2
short beeps
Bad timezone
1longbeep
followed by 3
short beeps
User lockout
3 rapid beeps
after c ode e ntered
or card presented
Code or Card is not found
4 quick beeps First-In Auto-unlock
6 quick beeps Toggle mode is active
4.1.1.E Resetting the Master Code and System
Defaults Only
Entering command 40 erases everything from the
prox.pad plus memory except the user list and trans-
action log and restores the default settings. This is
useful if the prox.pad plus unit has experienced pro-
gramming problems, or you wish to delete earlier pro-
gramming.
1. Place the prox.pad plus unit in Program mode.
Press:
99 # Master Code * (default is 1234)
A slow blinking yellow LED indicates that the unit is
in Program m ode. A steady yellow LED, in contrast,
means that errors w ere d etected during programming.
Table 4-2. prox.pad plus LED Indicators/
Sounder Operations (continued)
4.1 Programming Overview Chapter 4: P rogramming
prox.pad plus Install/Program. Manual, PPP, D2 4-5