User's Manual

Chapter 4:
Programming
4.1 Programming
Overview
Chapter 4 provides information about programming
the IEI prox.pad plus unit.
4.1.1 Programming
from the Keypad
The first step in programming the prox.pad plus unit
is to place it into Program mode. You can enter Pro-
gram mode with either the Master code or the Super-
visor code. When the prox.pad unit is in P rogram
mode, the yellow LED blinks slowly; when the yellow
LED stops blinking and is OFF completely, the unit is
no longer in Program mode. If an error is made in
Program mode, the yellow LED r emains steadily
lighted; press * to clear the error condition and then
re-enter the command. If the unit does not go into
Program mode, refer to the Troubleshooting Chart in
Chapter 5.
4.1.1.A Master Code (User #1)
TheMastercodeisaspecialcodestoredinuserlocation
one. This code is used to enter Program mode, and
has access to all programming commands.
To place the prox.pad plus unit in Program mode using
the Master code, press:
99 # Master Code *
NOTE: “1234” is the default Master code, which IEI
recommends that you change right away.
To change the Master code, enter:
1 # new master code * new master code *
(example, 1 # 4321 * 4321 *)
NOTE: Codes can be from 1 to 6 digits in length.
prox.pad plus Install/Program. Manual, PPP, D2 4-1