User Manual
18
To Disable / Enable a User Number
99# Master Code* Yellow LED Blinks
56# 0# = Enable (1# = Disable), User# Yellow LED Blinks
* Yellow LED Blinks Quickly
* Yellow LED Blinks Slowly (If Solid, see Note)
* Yellow LED Goes Out
To Set Unlock Time
Master Code* Yellow LED Blinks
11# Time Duration# (01-99sec) 0# Yellow LED Blinks
* Yellow LED Blinks Quickly
* Yellow LED Blinks Slowly (If Solid, see Note)
* Yellow LED Goes Out
The Unlock Time is adjustable foe Momentary Operation. A 5 Second unlock time is
recommended to extend battery life. Once the unlock time is entered, it is the same for
ALL users except 02.
Status Indicators
No Green LED after code is entered once, but flashes after 3 consecutive entries- Invalid Code
4 Long beeps after code is entered - Low Battery
4 long beeps after code is entered, 4 more long beeps - Voltage (batteries) to low to operate
Enter Supervisory Code to gain 1 entry.
LU and PK Programming
To determine which programming steps to use for your lock see the example
below:
If your label has a LU or PK then use the programming below.
If your label has a LK turn to LK programming.
Change the Master Code
99# 1234* Yellow LED Blinks
1# Yellow LED Blinks
New Master Code* Yellow LED Blinks Quickly
New Master Code* Yellow LED Blinks Slowly (If Solid, see Note)
* Yellow LED Goes Out
This example uses the Factory Default 1234*, yours may differ.
It is recommended not to use the factory default master code.
To Enter the Emergency Code
99# Master Code* Yellow LED Blinks
2# Yellow LED Blinks
Emergency (1-6 Digit)* Yellow LED Blinks Quickly
Emergency (1-6 Digit)* Yellow LED Blinks Slowly (If Solid, see Note)
* Yellow LED Goes Out
Emergency Codes Default to a 10 Second Unlock Time
-
+
-
+
-
+
-
+
+
-
+
-
LU PK