User Manual
22
To Erase Transaction Log
99# Master Code* Yellow LED Blinks
76# 00000# 00000# Yellow LED Blinks
* Yellow LED Blinks Quickly
* Yellow Blink, Green Fast
* Yellow LED Blinks Slowly (If Solid, see Note)
* Yellow LED Goes Out
Note: If the Yellow LED becomes Solid rather than blinking, a mistake has been made.
Depress the * Button until the Yellow LED goes out and start programming again.
Status Indicators
3 very rapid beeps after User Code entered - Invalid User Code
4 long beeps after User Code entered - Low Battery Indication
4 long beeps after User Code entered, 4 more long beeps - Voltage too low to operate
1 beep after User Code entered - disabled user
4 beeps after User Code entered - deadbolt thrown (8200 Series)
3 beeps after User Code entered - user lockout
Alternating red/green LED — Awaiting second entry of Code/Card or FOB user
PA Programming
To determine which programming steps to use for your lock see the example
below:
If your label has a PA and no keypad or front bezel then use the
programming below.
If your label has an LK turn to LK Programming.
If your label has an LU or PK turn to LU or PK Programming
In a Prox Only (PA) configuration, all programming must be completed using SofLink™ Plus
Software, Part Number 52-2412. The Software includes a convenient User’s Manual, Part
Number A7462, to be used as a programming guide.
First Time Programming
During the Programming sequence of downloading data from the PC to the PA Controller, a prox
card must be presented to the controller to wake up the unit. This is followed by pressing the
CommEnable Push Button for at least one second. When the SofLink™ Plus Software displays:
“Please enter your master code at the controller and then click OK”.
Reprogramming
Any user can be designated as a “CommEnable” user type by selecting the user type in SofLink.
When this is done, presenting the prox card with a person selected as a “ComEnable” user will
allow the unit to wake up and initiate the communications channel to the PC without the need to
press the CommEnable push button.
-
+
-
+
-
+
-
+
+
-
+
-
PA
Comm Enable
Push Button