User Manual

11
Outside of
Door
Mortise lockbody
connector and wire
*8-32
Flat Head
Screw
Keypad/prox connector
and cable
From the outside of the door, feed wires and
connector through fire stop plate
To secure the adapter and plate
assembly to the inside of the door,
thread the screws mounting posts
of the outside lever assembly.
Tighten retaining nut by hand.
Back off retaining nut slightly
until star pattern lines up with
square lever assembly corners
Insert Spindle into square
hole on inside
of door.
With outside lever horizontal, carefully insert the mounting
posts through the door and lockbody. Make sure the spindle
is properly engaged in the lock.
NOTE: For installation of optional gasket
Part #82-0500 see Gasket Installation
Locate (2) #8-32 Flat Head Screw and insert through the
escutcheon into the outside escutcheon. Tighten firmly.
Plug Keypad Connector
into inside Escutcheon
as shown. Place excessive
wire in hole.
Plug smaller Connector
as shown into the inside
Escutcheon. Place
excessive wire in inside
escutcheon assembly.
Keep excessive wires
away from cylinder hole.
NOTE:
Both connectors go on
only one way. Do not
offset the connectors.
Be sure connectors are
seated completely.
If not seated, Keypad
will not function properly.
Installation Instructions (Continued)
Step #3 Installation of Outside/Inside Escutcheon & Lever Assembly