User Manual

8
Installation Instructions (Continued)
How to Reverse Lock Hand
If it is necessary to change hand of locking piece
:
1. Turn lockbody to side NOT marked with RED locking piece.
2. Insert blade of common screwdriver into locking piece slot.
3. Push locking piece toward front of
lockbody and rotate until RED shows.
4. RED indicates locked (outside) side.
5. Wire harness MUST exit thru non-cylinder side.
If it is necessary to change hand Latchbolt
:
1. Insert blade of common screwdriver into oval slot behind latchbolt.
2. Push latchbolt out until back of bolt
clears lockbody front.
3. Rotate latchbolt 180¡ until the latchbolt
drops back into the lockbody.
Right Hand
Shown
Oval slot
Locking
guide slot
Rotate
Push
out
Push in
Push
out
RED color
locking piece
indicates locked side
End Cap
End Cap
Connector
Latchbolt
Outside of
Door