User's Manual

A7817A

Section 1: Introduction

1.1 Product Description

The Profile Series v.N1 Access Control Lock is designed to integrate into an existing

Wiegand access control system.

The unit consists of three components: the Reader(s), the Interface Module and the

Auxiliary Relay Board. The Reader resides within the exterior escutcheon on each door

and connects to the prox antenna, the keypad and it wires back to the Interface Module.

The Interface Module connects the v.N1 system to the access control system and it

supports from one to four Readers.

The third component is the Auxiliary Relay Board. These relay outputs are controlled by

the Latch Bolt and Deadbolt switches in lock bodies. Refer to section 4.8 for further

details.

1.2 Product Features

• Supports 1 to 4 Doors

• Card Reader is 39-bit HID Compatible

• Keypad Data is Sent as 8-bit Burst

• RX (Request to Exit)

• Door Position Switch Monitor

• Deadbolt Monitor

• Latch Bolt Monitor

• Supports Fail-Safe and Fail-Secure Solenoid Locking Devices

NOTE:

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.