User's Manual

A7817A

4.4 Wiring the Reader to the Interface Module Using One

Power Supply

The Diagram below shows how to wire the Reader to the Interface Module using a

single power supply. If you are connecting multiple Readers (up to 4), wire them in

parallel using terminal strips TS2 and TS3, following the diagram below. The chart also

shows these connections. Connect the power supply to TS1 as shown.

Reader Interface Module

J2: Pin 1 TS2/TS3: Data B

J2: Pin 2 TS2/TS3: Data A

J2: Pin 3 TS2/TS3: +12-30VDC

J2: Pin 4 TS2/TS3: GND

E1 Earth Ground Tab TS2/TS3: EGND

Note: The earth ground tab E1

on each Reader must be

connected to the mounting

screw in the rear housing as

shown in the diagram.