User Manual

Action Press Details
17. Program
consecutive “card
only” users by
presentation
53 # type # start user # **
<present card> <present card>...
Start user must be
greater than 2;
master/supervisor
cannot be set as
“card only”
18. Enable/disable
user
56#s/c#user#**
1=disables the
specified user
0=enables that
user
The master user
cannot be
disabled. A
non-programmed
user cannot be
enabled or
disabled
(generates
program error)
19. Program block
of 26-bit “card
only” users without
presenting cards
57 # number of users # start user #
card pin * card pin *
Start user must be
greater than 2;
master/supervisor
cannot be set as
“card only”
Uses site ID set in
command 32,
parameter 4
20. Delete block of
consecutive users
58#startuser#startuser#
number of users * number of users*
1.5 Programming Commands
DoorGard LS2/LS2P System Programming Manual, D3 1-31