User Manual

To program a 26-bit “card only” user without present-
ing a card, enter:
51 # type # location # card pin *
card pin *
NOTE: Location must be greater than 2; master/super-
visor cannot be set as “card only.”
To program a “card OR code” user, enter:
52 # type # location # key pin *
key pin * <present card>
To program a consecutive “card only” user by presen-
tation, enter:
53 # type # start user # **
<present card> <present card>...
NOTE: Start user must be greater than 2; master/su-
pervisor cannot be set as “card only.”
To program a block of 26-bit “card only” users without
presenting cards, enter:
57 # number of users # start user # card
pin * card pin *
NOTE: Start user must be greater than 2; master/su-
pervisor cannot be set as “card only.”
Uses site ID set in command 32, parameter 4.
1.4 Programming Users
DoorGard LS2/LS2P System Programming Manual, D3 1-25