User Manual

A slow blinking yellow LED indicates that the
system is in program mode.
2. Enter the user type to be applied to the user being
added followed by #. For example, a single use
code is entered as 5#, or a toggle code as 0#. Table
1-3 describes user types.
3. LOCATION: Press the user location number that
represents the user to be added or changed fol-
lowed by a pound symbol #. For example, user
location ten would be entered as 10 #
4. CODE: Enter the one- to six-digit code and an
asterisk *, for example, 532346*.(Thecomplete
sequence is 5 # 10 # 532346 * 532346 *.) The
yellow LED blinks rapidly, indicating that you
should verify the new code by entering it again
(along with an asterisk). If the system accepts the
code, the yellow LED begins blinking slowly. (A
steady yellow LED, in contrast, means that errors
were detected during programming. Error states
can be cleared by pressing the asterisk * key.)
5. To add more codes, return to step 2.
6. Press * to exit program mode.
1.4.4.A Examples
To add/delete a user, enter on of the following options:
50 # type # location # key pin *
key pin * - “code only” user
50 # type # location # **
<present card> - “card only” user by pres-
entation
50 # type # location # key pin *
key pin * <present card> - “card AND
code” user
50#0#location#**-deleteuser
1.4 Programming Users
1-24 DoorGard LS2/LS2P System Programming Manual, D3