User Manual

There are several different ways to add users, depend-
ingonwhatyouaretryingtoaccomplish.Seethe
command list for a complete list of commands. To add
a “code only,” “card only,” or a “card AND code” user,
employ command 50, although the 50 can be left off
the command. The same command is used to delete
users.
To add a “card only” user without presenting a card,
use command 51. When this command is used, you
enter the PIN number on the 26-bit Wiegand card.
Tobuildthecompletecardnumber,thekeypadused
the site ID set in command 32 parameter 4, which is
defaulted to 11. This number is not used to verify site
ID when cards are presented, but just to identify that
specific card. This means you can have cards with
several different site ID’s programmed into an
LS2/LS2P system. You can program a number of con-
secutive cards in this fashion using command 57.
If you want to add consecutive cards by presentation,
use command 53.
If you want to delete a block of users, use command
58.
You can also disable users by using command 56.
1.4.2 User Codes
DoorGard LS2/LS2P user codes consist of a minimum
of one digit and a maximum of six digits. A complete
list of program commands is supplied in Table 1-4.
Attempting to program a user code into memory that
had been entered previously into a different location,
causes the yellow LED to stop blinking and remain
steadily lighted. If this occurs, try entering a different
user code. Repeating digits in the same code is accept-
able. The same code cannot be programmed more than
once.
1.4 Programming Users
1-22 DoorGard LS2/LS2P System Programming Manual, D3