User Manual

Table 1-4. User Types
User Type Numeric ID Description
Toggle 0
Toggle users latch the lock in the unlock
position. Toggle mode is indicated by 6
quick beeps and a solid green LED.
Standard 1
Standard users use the lock duration
programmed in command 11.
Lockout 3
Lockout users “lock out” other users -
see User Lockout (section 1.3.5). These
codes do not unlock the door.
Extended Unlock 4
Extended Unlock Users are like standard
users except they use the unlock
duration programmed in command 32
option 3.
Single Use Code 5
SingleUseCodesarecodesthatcan
only be used once. To verify a Single
Use is programmed, enter the sequence
[5# PIN *] and this looks up the PIN and
generates a 1/2 second green flash if the
PIN is programmed as a single use code.
If the PIN is not found, the system
generates 3 quick beeps and increments
the invalid PIN counter. If PIN is found
but is not programmed as a single use
code, the system does not respond at all.
Relock 6
Relock codes are used to relock the door
when a toggle or auto-unlock is active.
Emergency 7
Emergency users are special users that
cannot be locked out and operate below
the Low Voltage Inhibit Threshold. The
user also uses the unlock duration
programmed in command 32 option 3.
Comm. Enable 8
Comm Enable User (Communications) is
used to enable communications, which
allows transfer of data to/from the PDA to
the LS2/LS2P system. This code does
not unlock the door.
1.4 Programming Users
DoorGard LS2/LS2P System Programming Manual, D3 1-21