User Manual

command 30. NOTE: Acommonreasontoturnthis
feature OFF is to prevent an unauthorized user from
hearing the audio feedback emitted when an author-
ized user enters his/her code.
1. Place the DoorGard LS2/LS2P system in program
mode. Press:
99 # Master Code * (default is 1234)
A slow blinking yellow LED indicates that the
system is in program mode.
2. To enable this feature, press:
30#0#1#**
The yellow LED continues to blink slowly. (A
steady yellow LED, in contrast, means that errors
were detected during programming. Error states
can be cleared by pressing the asterisk * key.)
3. To disable this feature, press:
30#0#0#**
The yellow LED continues to blink slowly.
4. Press * to exit program mode.
1.3.8 Turning Visual
LED/Keypress
Indicator ON/OFF
This visual LED/keypress indicator lights the visual
LED once for each key press. This feature provides a
visual acknowledgment that a particular key was
pressed hard enough for the system to understand.
The factory-shipped default setting is ON, but it can
be toggled ON and OFF as desired. NOTE: A common
reason to turn this feature OFF is to prevent an un-
authorized user from viewing visual feedback pro-
duced when an authorized user enters his/her code.
1. Place the DoorGard LS2/LS2P system in program
mode. Press:
99 # Master Code * (default is 1234)
A slow blinking yellow LED indicates that the
system is in program mode.
1.3 Programming Keypad Options and Parameters
DoorGard LS2/LS2P System Programming Manual, D3 1-11