ASSEMBLY INSTRUCTIONS Description Item No.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Short bolt ( M6 x 40mm) 3 Sketch NO Description Qty 3 2 Medium bolt (M6 x 60mm) 4 Long bolt (M6 x 80mm) 6 4 Medium screw (M4 x 35mm) 8 5 Short screw (M3.5 x 15mm) 2 6 Lock Washer (6.5 x11mm) 15 7 Flat Washer (6.5 x19mm) 13 8 Caster 4 9 Allen Key (M4x80mm) 1 10 Wood plug (14.
STEP 1 Attach seat frame (B) to the back (A) with bolts (1) and (3), washers (7) and (6), as shown below. Tighten with Allen key (11). Note: DO NOT tighten any of the bolts, until the chair is assembled, then put on a flat level surface to make sure the chair is level and then tighten the bolts. STEP 2 Attach front legs (D) to the seat frame (B) with bolts (2), and washers (7) and (6). Tighten with Allen key (11). Place side stretchers (E) and middle stretcher (F) between front and back legs.
STEP 3 Attach casters (8) to the front legs (D) and back (A) as shown below. STEP 4 Attach Arms (G) to seat frame with bolts (3), and washers (6) and (11). Tighten with the Allen key (9). Then use Nuts (13), and washers (6) and (7) as shown below. Tighten with the Wrench (14). Attach Arms (A) to the back with screws (12). Tighten with a screwdriver.
STEP 5 Attach the seat (C) to top of the seat frame (B) with screws (4), as shown below. Tighten with a screwdriver. Then insert wood plugs (4) over bolts to cover them.
