User's Manual
Table Of Contents
- Finding information with Access ThinkPad
- Contents
- Chapter 1. Overview of your new ThinkPad computer
- Chapter 2. Solving computer problems
- Chapter 3. Getting help and service from IBM
- Appendix A. Important safety instructions
- Appendix B. Warranty information
- Appendix C. Wireless regulatory information
- Appendix D. Notices
- Processing date data
- References to the Web site addresses
- Electronic emission notices
- Telecommunication notices
- Industry Canada requirements
- Notice for Australia
- Notice for New Zealand
- Notice for European Union countries
- Wireless Interoperability
- Usage environment and your Health
- Product notice requirements
- Trademarks
- Index
Solution: The battery power is getting low. Connect the ac adapter to the
computer, or replace the battery with a fully charged one.
Problem: When you take action to return from standby mode, the computer
display remains blank.
Solution: Check whether an external monitor was disconnected while the
computer was in standby mode. Do not disconnect the external monitor while
the computer is in standby mode or hibernation mode. If no external monitor
is attached when the computer resumes, the computer display remains blank
and output is not displayed. This restriction does not depend on the
resolution value. Press Fn+F7 to bring up the computer display.
Problem: The computer does not return from standby mode, or the standby
indicator stays on and the computer does not work.
Solution: If the system does not return from standby mode, it may have
entered standby or hibernation mode automatically because the battery is
depleted. Check the standby indicator.
v If the standby indicator is on, your computer is in standby mode. Connect
the ac adapter to the computer; then press Fn.
v If the standby indicator is off, your computer is in hibernation mode or
power-off state. Connect the ac adapter to the computer; then press power
button to resume operation.
If the system still does not return from standby mode, your system may stop
responding and you cannot turn off the computer. In this case, you need to
reset the computer. If you have not saved your data, it may be lost. To reset
the computer, press and hold the power button for 4 seconds or more. If the
system is still not reset, remove the ac adapter and the battery.
Problem: Your computer does not enter standby or hibernation mode.
Solution: Check whether any option has been selected that would disable
your computer from entering standby or hibernation mode.
Problem: The computer does not enter standby mode as set by the timer
under Windows 98 or Windows NT.
Solution:
For Windows 98:
The generic CD-ROM or DVD-ROM driver for Windows 98 accesses the
internal CD-ROM or DVD-ROM drive every 3 seconds to see whether a
Solving computer problems
Chapter 2. Solving computer problems 19