International Business Machines Model: WM3B2200BG(WLAN 802.11bg Adapter) : User's Manual : Page 29

The “Modem on Hold” feature of V.92 modems requires compliance by the

modem, the Public Switched Telephone Network (PSTN) and the Internet

Service Provider (ISP). This modem may not handle Modem on Hold correctly

when connected to the Telecom New Zealand PSTN even when it is loaded

with the correct V.92 software. If problems occur with the operation of

Modem on Hold do not report them to the Telecom Fault Service or a charge

may be imposed on the customer.

This equipment is not capable, under all operating conditions, of correct

operation at the higher speeds for which it is designed. Telecom will accept no

responsibility should difficulties arise in such circumstances. This condition

typically applies to 56 kbit/s modems and facsimile machines operating at

>14.4 Kbit/s.

This equipment may not provide for the effective hand-over of a call to

another device connected to the same line.

Under power failure conditions this appliance may not operate. Please ensure

that a separate telephone, not dependent on local power, is available for

emergency use.

Some parameters required for compliance with Telecom’s Telepermit

requirements are dependent on the equipment (PC) associated with this

device. The associated equipment shall be set to operate within the following

limits for compliance with Telecom’s Specifications:

1. There shall be no more than 10 call attempts to the same number within

any 30 minute period for any single manual call initiation, and

The equipment shall go on-hook for a period of not less than 30 seconds

between the end of one attempt and the beginning of the next call attempt.

2. Automatic calls to different numbers shall be spaced such that there is not

less than 5 seconds between the end of one call attempt and the beginning

of another.

This

equipment shall not be set up to make automatic calls to Telecom’s 111

Emergency Service.

In order to operate within the limits of compliance with Telecom’s

specifications, equipment shall be set to ensure that calls are answered within

30 seconds of the receipt of ringing. ‘The facsimile rings to answer setting’

should be configured to a maximum of 10 rings to comply with this

requirement.

24 ThinkPad

®

X41 Tablet Series Regulatory Notice