User Manual

Chapter 3 — Troubleshoot and Maintain the Printer
28 PR2 and PR3 Mobile Receipt Printer User Manual
Print a Test Label
1 Turn off the printer by pressing and holding the Power button for
5 seconds. After 2 seconds, the three LEDs blink once, and after 5
seconds the three LEDs blink three times. The printer turns off.
2 Press and hold the Print button, and then press and hold the
Power button. The blue Intermec Ready-to-Work™ indicator
starts to blink.
3 Continue to hold the buttons until the Ready-to-Work indicator
stays on solid (about 15 seconds). The printer prints a test label.
Problems and Possible Solutions
Use this table to understand and troubleshoot some common errors
you may encounter.
Bluetooth
Configuration
Device Address
Device Name
Reserve
Authentication
Encryption
Connectable
Discoverable
Battery Serial Number
Charge Cycles
Battery Voltage
Magnetic Stripe
Reader
Installed
Test Label Contents (Continued)
Category Contents
Problems and Possible Solutions
Problem Possible Solution
Printer does not feed media
correctly.
Remove the media from the media
compartment and reinstall the media.