User`s manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the Printer
- Chapter 2 - Connecting the Printer
- Chapter 3 - Configuring the Printer
- Configuring Your Printer
- Configuring Your Printer From the Screen
- Configuring Your Printer From the Printer Home Page
- Configuring Communications Settings
- Configuring Media Settings
- Configuring RFID Settings (PF2i With RFID Option)
- Configuring Print Engine Settings
- Configuring Web Shell Settings
- Configuring Alerts
- Configuring General Network Settings
- Configuring Mail Settings
- Configuring SNMP Settings
- Configuring TCP/IP Settings
- Configuring the Network Type
- Configuring Avalanche Settings
- Configuring SmartSystems Settings
- Configuring Wireless LAN Settings
- Configuring 802.1x Settings
- Configuring Your Printer With PrintSet
- Configuring Your Printer With Commands Sent From Your PC
- Configuring Your Printer Using SmartSystems Foundation
- Configuring Your Printer Using Wavelink Avalanche
- Choosing an Ethernet or Wireless Network
- Upgrading Firmware
- Downloading Fonts and Graphics
- Configuring Your Printer
- Chapter 4 - Troubleshooting and Maintaining the Printer
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Fingerprint and IPL Setup Menus
- Appendix D - Advanced Configuration
Appendix B — Default Settings
146 PF2i and PF4i Mid-Range Printer User’s Manual
Default Configuration
The following tables list the default values of the configuration
commands supported on the PF2i and PF4i. If you restore the printer
to factory default settings, the printer uses these values.
The commands are grouped by function and reflect the organization
of the IPL and Fingerprint setup menus. For detailed information on
most of the commands, see the Intermec Fingerprint Command
Reference Manual or the IPL Command Reference Manual. You can
download both documents from the Intermec web site at
www.intermec.com.
Fingerprint Default Configuration
Ser-Com “uart1:” Parameters
Parameter Default Value
Baud rate 9600
Character length 8
Parity None
Stop bits 1
Flow control
RTS/CTS
ENQ/ACK
XON/XOFF; data to host
XON/XOFF; data from host
Disable
Disable
Disable
Disable
New line CR/LF
Receive buffer 1024 bytes
Transmit butter 1024 bytes
Net-Com “net1:” Parameters
Parameter Default Value
New line CR/LF