User Manual

Appendix A — Specifications
56 PB22/PB32 Mobile Label and Receipt Printer User’s Guide
• You can use higher caliper media in the printer, but print quality
will be reduced.
• Receipt roll stock media has an end of roll indicator. The end of
roll indicator is a red marking (on the last 3 feet of the roll) on the
thermally sensitive side of the paper.
Specialty media is required for unique customer environments,
including printer operating temperature extremes. Intermec
recommends that you test the media in your application.
Supported Media
The PB22/PB32 printer supports direct thermal label, tag, and receipt
media. Both North American and European label media are
supported in multiple label lengths. Receipt media is supported in
both a top coated and an uncoated paper in continuous roll stock
only.
The default media sensitivity number is: 180.
Use the following table as a guide when setting sensitivity numbers.
External Fanfold Media Specifications
Stack height: 70 mm (2.75 in)
Page length: 152 mm (6 in) to 305 mm (12 in)
Note: A 6-inch page length is supplied in 12-inch long stacks (two
6-inch stacks of equal height with the bottom page linked).
Recommended Media Sensitivity and Constant
Sensitivity Constant Description
North American Label Media
720 60 Duratherm Lightning Plus
470 52 Duratherm Lightning Perm
450 48 Duratherm III IR
430 100 Duratherm III Synthetic
180 80 Duratherm II Label
180 80 Duratherm III Label
180 80 Duratherm Near IR