User Manual

Chapter 2 — Configuring the PB22/PB32
PB22/PB32 Mobile Label and Receipt Printer User’s Guide 31
2 Connect the other end of the serial cable to a serial port on the
back of your PC.
3 Open HyperTerminal on your PC and configure the following
parameters for the serial port:
4 From the host PC, check the wireless settings.
If you have an IPL version of the printer, send these commands to
the PB22/PB32:
<STX><SI>wt,SSID<ETX>
<STX><SI>wt,WEP1<ETX>
<STX><SI>wt,WEP2<ETX>
<STX><SI>wt,WEP3<ETX>
<STX><SI>wt,WEP4<ETX>
<STX><SI>wt,AUTH<ETX>
<STX><SI>wt,WPA<ETX>
<STX><SI>wt,WPA2<ETX>
<STX><SI>wt,WPA_PSK<ETX>
<STX><SI>wt,ROAM<ETX>
<STX><SI>wt,PWR_MODE<ETX>
<STX><SI>wt,CHANNEL<ETX>
<STX><SI>wt,AP_MAC<ETX>
<STX><SI>wt,SIGNAL<ETX>
<STX><SI>wt,SPEED<ETX>
<STX><SI>wt,ACTIVE<ETX>
If you have a Fingerprint version of the printer, send this
command to the PB22/PB32:
setup write "wlan","uart1:"
5 Set up the PB22/PB32 to use the correct SSID and authentication
modes. See one of the following procedures to configure wireless
printing on your IPL or Fingerprint printer.
6 If you are going to use certificates for validation, transfer the
certificate to the printer. The printer can accept .pfx, .pem, and
.der certificates.
Parameter Default Setting
Baud rate 115200
Data bits 8
Parity None
Stop bits 1