User`s manual

Chapter 2 — Configuring Network Settings
24 IF30 Fixed Reader User’s Manual
Configuration Settings For Your Network
This chapter assumes that you are using the IF30 web browser
interface to configure network settings on the IF30. For help, “Using
the Web Browser Interface” on page 14.
You can also configure network settings by:
• using a communications program to access the IF30. For help, see
“Using a Communications Program” on page 10.
• using Intermec Settings from within the Intermec SmartSystems
Console. For help, see “Using SmartSystems Foundation” on
page 56.
Configuring Ethernet Settings
This section explains how to configure the wired Ethernet settings
using the web browser interface:
• DHCP mode
• (If DHCP is enabled) DHCP server name, user class, and vendor
class
• IP address
• IP subnet mask
• IP router (gateway)
• Link speed
For help with enabling IPv6 and configuring settings, see “Enabling
IPv6” on page 27.
Note: If you are using a DHCP server, you may not need to configure
Ethernet settings. For more information, contact your network
administrator.