User`s manual

Chapter 1 — Getting Started
8 IF30 Fixed Reader User’s Manual
Understanding the Rear Panel Ports
The ports on the rear panel are used for connecting the IF30 to RFID
antennas.
IF30 Rear Panel Ports: This illustration shows the ports on the rear panel. The
IF30 ships with antenna terminators mounted on RFID antenna ports 2, 3, and
4.
The IF30 RFID antenna ports use these connectors:
• 865-869 MHz: SMA
• 915 MHz: Reverse SMA
Make sure you have appropriate antennas and cables for your IF30.
For help, contact your Intermec sales representative.
RFID antenna
ports (4 places)
Terminators
Government regulatory agencies require that this RFID reader
only use approved antennas. Therefore, this reader uses a custom
antenna connector. Do not use antennas not approved for use
with this reader.
Note: The IF30 ships with antenna terminators installed on RFID
antenna ports 2, 3, and 4. Do not remove the terminator from any port
unless you are installing an antenna or antenna cable on that port.