User`s manual

Chapter 3 — Configuring the CV60
CV60 Vehicle Mount Computer With Windows CE User’s Manual 31
The CV60 support these network protocols:
•TCP/IP
• UDP Plus
In a TCP/IP network, the CV60 communicates with a host
computer directly using TCP/IP. The access point acts as a bridge
to allow communications between the wired network and the
wireless network.
To use wireless communications in a TCP/IP network
1 Go to Start > Settings > Control Panel > Intermec Settings.
2 Configure these network parameters on each CV60 in the
network:
• Network name (SSID)
• IP settings (if not using DHCP)
3 Configure security. For help see, “Configuring Security on
the CV60” on page 32.
4 Make sure that the CV60 is talking to the network and that
the network can see the CV60.
The easiest way to configure the network parameters on the
CV60 is to use Intermec Settings. For help, see “Configuring the
CV60 Using Intermec Settings” on page 22.
Configuring the Network Parameters for a UDP Plus Network
In a UDP Plus network, the CV60 communicates with a host
computer through the Intermec Application Server. The
Intermec Application Server translates UDP Plus packets on the
wireless network into TCP/IP packets on the wired network and
vice versa. An access point acts as a bridge to allow
communications between the wired network and the wireless
network.
To use wireless communications in a UDP Plus network
1 Go to Intermec Settings > Communications > UDP Plus.
2 Configure these network parameters on each CV60 in the
network:
• Network name (SSID)