User`s manual

Chapter 3 — Configuring the CV60
26 CV60 Vehicle Mount Computer With Windows CE User’s Manual
Configuring the CV60 to Communicate With a Wireless Scanner
This section explains how to configure the CV60 to
communicate with Bluetooth wireless scanners. The CV60 ships
with a Bluetooth association label attached to the left side. Scan
the association label to quickly connect the CV60 to the
Bluetooth wireless scanner.
If for some reason the Bluetooth association label does not work,
you can follow the procedure for configuring the CV60 from
Intermec Settings at the end of this section.
To configure Bluetooth communications on the CV60
1 Select Start > Settings > Control Panel > Intermec Settings.
2 Select Communications > Bluetooth.
3 If you want to allow incoming connections from wireless
scanners, you must enable these two parameters:
•Discoverable
• Connectable
If you do not want to allow incoming connections, make sure
both parameters are disabled.
4 Save your changes and exit Intermec Settings.
To connect to the wireless scanner using the association label
1 Using your wireless scanner, scan the Bluetooth association
label on the side of the CV60.
2 The CV60 prompts you to enter the passcode for your
scanner. The default passcode for Intermec Bluetooth
scanners is
0000.
3 Tap Finish.
To connect to the wireless scanner using the Bluetooth Scanner Wizard
1 Make sure Bluetooth communications is enabled. For help,
see “Setting Up Bluetooth Communications” on page 24.