User`s manual

Chapter 3 — Configuring the CV60

24 CV60 Vehicle Mount Computer With Windows CE User’s Manual

To use the CV60 in an Ethernet network

1 Go to Start > Settings > Control Panel > Intermec Settings.

2 If you have a DHCP server, enable DHCP.

If you do not have a DHCP server, set these parameters:

• IP address

•Subnet mask

• Default router

3 If required for your network, you may also need to set these

parameters on each CV60:

• Primary and secondary DNS servers

• Primary and secondary WINS servers

4 Make sure your CV60 is talking to the network and that the

network can see your CV60.

Setting Up Bluetooth Communications

You can send information to a Bluetooth device wirelessly using

the standard Bluetooth radio in the CV60. The Bluetooth

technology uses a short-range radio links and allows for

communications over a 10 meter (32.8 foot) range.

You can use the Bluetooth radio to connect to these wireless

devices:

• Scanners

•Printers

• Headsets

Note: The easiest way to configure the network parameters on the

CV60 is to use Intermec Settings. For help, see “Configuring the

CV60 Using Intermec Settings” on page 22.

Note: The performance of Bluetooth varies depending on

location, the Bluetooth device, and other environmental

parameters.