User's Manual

Chapter 6 — Configure the Computer
CN51 Mobile Computer User Manual 87
By default, the 802.11 radio is disabled. Use the following procedure to
enable the Wi-Fi radio using Intermec Settings.
1 Tap Start > Settings > System > Intermec Settings.
2 From the Intermec Settings main menu, tap Communications >
802.11 Radio > Radio Enabled.
3 Select the Radio Enabled check box and tap OK. By default, the
computer uses Funk security and enables DHCP.
To enable both the 2.4 GHz and 5.0 GHz bands for the
802.11a/b/g/n radio, from the Intermec Settings 802.11 Radio
menu, tap Radio Bands and select a/b/g (2.4 and 5.0 GHz).
4 Use Intermec Settings to configure the parameters you need to use
for communications with your network.
5 Configure 802.11 security.
About Bluetooth Communications
The CN51 is Bluetooth-enabled, which lets you connect to other
Bluetooth devices such as:
• scanners.
• printers.
• audio devices.
You need to turn on the Bluetooth radio before you can discover and
connect to Bluetooth devices. By default, the radio is turned off.
The Bluetooth radio maintains its current state through a warm or
cold boot and maintains virtual COM ports. If you clean boot the
computer, you must recreate pairings to devices.
System bar icons indicate Bluetooth status.