User's Manual

Chapter 6 — Configure the Computer
CN51 Mobile Computer User Manual 97
5 For Association, select WPA or WPA2.
The default encryption is TKIP or AES, respectively.
6 For 8021x, select None.
7 For Pre-Shared Key, enter the pre-shared key or passphrase:
• Enter the pre-shared key (0x followed by 32 hexadecimal pairs)
for your access point.
• Enter the passphrase (8 to 63 ASCII characters) for your
authenticator. The computer internally converts the passphrase
to a pre-shared key.
8 Tap OK.
Configure 802.1x Security with Funk Security
Before you set 802.1x-WEP security with Funk security, you need to
enable the radio on your computer and set the date. To use TLS
protocol, you also need to load a user and root certificate. Intermec
recommends that you use WPA2-802.1x instead of 802.1x-WEP if
possible.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select a Funk security profile to configure.
4 Enter the SSID.
5 For Association, select Open.
6 For Encryption, select WEP.
7 For 8021x, select TTLS, PEAP, or TLS.
8 If you selected TTLS or PEAP:
a For Prompt for Credentials, select Enter credentials now.
b Enter a User Name and a User Password.
9 If you selected TLS, enter a User Name and Subject Name.
10 For Validate Server Certificate, select Yes.
11 Tap OK.