User's Manual

Chapter 2 — Connecting and Configuring the CN50
44 CN50 Mobile Computer for Windows Mobile 6.1 User’s Manual
Configuring WPA or WPA2 with Funk Security
Use the following procedure to configure WPA or WPA2 with Funk
security.
1 Make sure the communications and radio parameters on your
CN50 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose WPA or WPA2.
7 For 8021x, choose None.
8 For Pre-Shared Key, enter the pre-shared key or passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the access point. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the CN50 internally converts it to a
pre-shared key. This value must match the passphrase on the
authenticator.
9 Save your settings.
Configuring 802.1x Security With Funk Security
Use the following procedure to configure 802.1x security with Funk
security.
1 Make sure the communications and radio parameters on your
CN50 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose Open.
7 For Encryption, choose WEP.