User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the CN50
- Chapter 2 - Connecting and Configuring the CN50
- Configuring the CN50
- Connecting to a PC
- Connecting to Your Network
- Configuring Wireless Security
- Configuring the Phone
- Connecting to an ISP
- Connecting to a Network With a VPN Server
- Chapter 3 - Developing and Installing Applications
- Chapter 4 - Troubleshooting and Maintaining the CN50
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Keypads and Keystrokes
- Appendix D - Imager Configuration Bar Codes
- Index
Chapter 1 — Using the CN50
18 CN50 Mobile Computer for Windows Mobile 6.1 User’s Manual
The area imager is equipped with a laser pointer to help you aim at bar
codes, allow you to read 2D bar code symbologies, and support
omni-directional (360°) scanning. Omni-directional scanning lets you
position the CN50 in any orientation to read a bar code label.
Reading Bar Codes
This section describes how to use the CN50 imager to read bar codes.
1 Press
^ to turn on the CN50.
2 Point the scanner window at the bar code label, and hold the CN50
steady a few inches from the label.
3 Press the Scan button. The laser pointer and illumination beam
and frame appear.
4 Use the laser pointer as a guide and aim toward the middle of the
bar code. Make sure that the illumination frame covers the bar code
you are trying to decode.
When the CN50 successfully reads a bar code label, you hear a high
beep, and the Good Read LED turns on briefly.
5 Release the Scan button.
Scan button