User's Manual

Chapter 1 — Using the CN3
34 CN3 Mobile Computer User’s Manual for Windows Mobile 6.1
2 Select a file save location, type a filename prefix, and select a
compression level.
3 Tap ok.
Installing a miniSD or SIM Card
The miniSD card and SIM card slots are located below a door inside
the CN3 battery compartment.
When the door to the miniSD is opened and closed (for changing,
installing, or removing the SIM or miniSD card), the CN3 performs a
cold boot after you install the battery. For more information, see
“Cold Booting the CN3” on page 98.
To insert a miniSD or SIM card
1 Press the Power button to suspend the CN3, and then remove the
battery. For help with removing the battery, see “Changing the
Battery” on page 5.
2 Locate the two screws on the miniSD/SIM card slot door.
3 Remove the screws and gently lift the door to the card slot.
4 Insert the SIM card or miniSD card as shown in the next
illustrations.
You can corrupt your miniSD™ card if you do not follow these
installation and removal procedures exactly. Before installing a
miniSD card, inspect the gasket in the compartment for any
damage or wear, and contact your Intermec representative if you
find any damage or wear.