Technologies Network Router User Manual

SECTION 4 " Configuration
6710 Access Point User’s Guide 4-13
Loading configuration from EEPROM
Command Description
File File system menu
View View/modify the configuration
Clear Set the configuration to default values
Read Read the configuration from EEPROM
Write Write the configuration to EEPROM
Reboot Restart using last written configuration
Exit Disconnect
? Display this help
>
The menu lists the commands you can use to do various
tasks, described on the following pages. The screen also
displays the command prompt (>). At the prompt, type the
name of the command you want to perform and press
[Enter]. (Commands are case insensitive.) The Main Menu
redisplays when you enter an invalid command.
The following chart describes how to use the commands.
Use To
File List file system commands and descriptions.
Section 5, “Software Download,” describes the
commands and file system methodology.
View View or modify configuration program settings.
See “Using the View Command” on page 4-14.
Clear
Reset the access point’s configuration to the facto-
ry-set default settings, which start on page 4-7.
Read Load the most recent configuration from
EEPROM. The configuration that was written to
EEPROM since the access point was last
rebooted becomes the new configuration.