Technologies Network Router User Manual

SECTION 5 " Software Download
6710 Access Point User’s Guide 5-31
Starting the TFTP Server
1. Configure the access point that you just upgraded to
be the TFTP server by typing:
File>tftp server start
2. To check the status of the TFTP server, type:
File>tftp server log
If the server is active its response is:
The TFTP server is running.
Upgrading TFTP Clients
The following procedure assumes that you are downloading
USTART29.BIN into an inactive boot segment and the 900
MHz radio’s data file into an inactive data segment.
1. After you have started the access point server,
establish a TELNET session with the access point to
be upgraded (the client).
2. Access the client’s File Menu.
3. On the client, type the following commands to upgrade
it.
Command Description
File>fe ib: Erase the client’s inactive boot
segment.
File>fe id: Erase the client’s inactive data
segment.
File>tftp get 1.2.3.4 ustart29.bin ib: Copy executable file
USTART29.BIN from the server
(IP address is 1.2.3.4) to the cli-
ent’s inactive boot segment.