Technologies Network Router User Manual

SECTION 4 " Configuration
4-56 6710 Access Point User’s Guide
[Values]
Use [Values] to enter pattern lists that contain byte
patterns that match consecutive bytes in received Ethernet
frames. Settings for [Values] are referenced by the Value Id
from the Expression Table. The values to be used in a filter
expression are as follows:
Value Id Value
1 0
2 0
3 0
.
.
.
22 0
Filter expression values have the following settings:
Value Id 0
Value
Setting Description
Value Id An identifier used by an expression in the Expres-
sion Table. The range is 0 (default) to 255. All
values with the same identifier are considered to
be in the same list. When used in an expression
that allows only one value (that is, LT, LE, GE, or
GT), only the first value in the list is used.
Value One of the values to be compared. The range is 8
hexadecimal pairs.